Check the laws and regulations on the use of mobile phones in the area when you
Do not use a hand-held phone while driving.
Give full attention to driving.
Pull off the road and park before making or answering a call if driving conditions so
RF energy may affect some electronic systems in your vehicle such as car stereos
When your vehicle is equipped with an air bag, do not obstruct with installed or
due to improper performance.
If you are listening to music whilst out and about, please ensure that the volume is
importance when near roads.
Avoid damage to your hearing
To prevent possible hearing damage, do not listen at high volume
levels for long periods.
Damage to your hearing can occur if you are exposed to loud sound for long periods of
time. We therefore recommend that you do not turn on or off the handset close to your
ear. We also recommend that music and call volumes are set to a reasonable level.
Guidelines for safe and efficient use
When using headphones, turn the volume down if you cannot hear the people
cause hearing loss
Some parts of your mobile device are made of glass. This glass could break if your
mobile device is dropped on a hard surface or receives a substantial impact. If the glass
breaks, do not touch or attempt to remove it. Stop using your mobile device until the
glass is replaced by an authorised service provider.
Do not use the phone where blasting is in progress. Observe restrictions and follow any
regulations or rules.
Potentially explosive atmospheres
Do not use your phone at a refueling point.
Do not use near fuel or chemicals.
Do not transport or store flammable gas, liquid or explosives in the same
Wireless devices can cause interference in aircraft.
Turn your mobile phone off before boarding any aircraft.
Do not use it on the ground without permission from the crew.
Keep the phone in a safe place out of the reach of small children. It includes small parts
which may cause a choking hazard if detached.
Emergency calls may not be available on all mobile networks. Therefore you should
never depend solely on your phone for emergency calls. Check with your local service
Battery information and care
You do not need to completely discharge the battery before recharging. Unlike other
Use only LG batteries and chargers. LG chargers are designed to maximise the
Do not disassemble or short-circuit the battery.
Replace the battery when it no longer provides acceptable performance. The battery
pack may be recharged hundreds of times before it needs replacing.
Recharge the battery if it has not been used for a long time to maximise usability.
Do not expose the battery charger to direct sunlight or use it in high humidity, such as
in the bathroom.
Guidelines for safe and efficient use
Do not leave the battery in hot or cold places, as this may deteriorate battery
There is risk of explosion if the battery is replaced with an incorrect type.
Dispose of used batteries according to the manufacturer's instructions. Please recycle
when possible. Do not dispose as household waste.
If you need to replace the battery, take it to the nearest authorised LG Electronics
Always unplug the charger from the wall socket after the phone is fully charged to
Actual battery life will depend on network configuration, product settings, usage
Make sure that no sharp-edged items such as animal’s teeth or nails, come into
For your safety, do not remove the battery incorporated in the product.
Hereby, LG Electronics declares that this LG-D802 product is in compliance
with the essential requirements and other relevant provisions of Directive
1999/5/EC. A copy of the Declaration of Conformity can be found at
Notice: Open Source Software
To obtain the corresponding source code under GPL, LGPL, MPL and other
open source licences, please visit http://opensource.lge.com/
All referred licence terms, disclaimers and notices are available for download
with the source code.
Regulatory and Safety
Go to "
System settings > General tab > About phone > Regulatory
Contact office for compliance of this product :
LG Electronics Inc.
EU Representative, Krijgsman 1,
1186 DM Amstelveen, The Netherlands
Disposal of waste batteries/accumulators
When this crossed-out wheeled bin symbol is attached to batteries/
This symbol may be combined with chemical symbols for mercury (Hg), cadmium
of cadmium or 0.004% of lead.
All batteries/accumulators should be disposed separately from the municipal
the local authorities.
The correct disposal of your old batteries/accumulators will help to prevent
please contact your city office, waste disposal service or the shop where you
purchased the product.
Disposal of your old appliance
When this crossed-out wheeled bin symbol is attached to a product it
the municipal waste stream via designated collection facilities appointed by
the government or the local authorities.
negative consequences for the environment and human health.
For more detailed information about disposal of your old appliance, please
purchased the product.
Please check to see whether any problems you encountered with your phone are
described in this section before taking the phone in for service or calling a service
1. Phone memory
When there is less than 10% of space available in your phone memory, your phone
cannot receive new messages. You need to check your phone memory and delete some
data, such as applications or messages, to make more memory available.
To uninstall applications:
Apps tab > Settings > General tab > Apps.
Once all applications appear, scroll to and select the application you want to
2. Optimizing battery life
Extend your battery's power by turning off features that you don't have to run constantly
in the background. You can monitor how applications and system resources consume
Extending your phone's battery life:
Turn off radio communications when you are not using. If you are not using Wi-Fi,
Reduce screen brightness and set a shorter screen timeout.
Turn off automatic syncing for Gmail, Calendar, Contacts and other applications.
Some applications you have downloaded may reduce battery power.
While using downloaded applications, check the battery charge level.
Please read this before you start using your phone!
NOTE: If you accidently press the Power/Lock Key while the device is in your
pocket, the screen will turn off automatically in order to save battery power.
To check the battery power level:
Apps tab > Settings > General tab > About phone >
The battery status (charging or discharging) and battery level (percentage charged) is
displayed at the top of the screen.
To monitor and control how battery power is being used:
Apps tab > Settings > General tab > About phone >
Battery > Battery use.
Battery usage time is displayed on the screen. It tells you how long it has been since
you last connected your phone to a power source or, if currently connected, how long
the phone was last running on battery power. The screen shows the applications or
services using battery power, listed in order from the greatest to smallest amount used.
3. Before installing an open source application and OS
If you install and use an OS other than the one provided by the manufacturer
be covered by the warranty.
To protect your phone and personal data, only download applications from
applications on your phone, the phone may not work normally or a serious
error may occur. You must uninstall those applications and all associated data
and settings from the phone.
4. Using an unlock pattern
Set an unlock pattern to secure your phone. Tap
Settings > Display tab > Lock screen > Select screen lock > Pattern. This opens
a screen that will guide you through how to draw a screen unlock pattern. You have to
create a Backup PIN as a safety measure in case you forget your unlock pattern.
Caution: Create a Google account before setting an unlock pattern and
remember the Backup PIN you created when creating your pattern lock.
Precautions to take when using pattern lock.
able to access your phone if you use an incorrect pattern 5 times. You have 5
opportunities to enter your unlock pattern, PIN or password. If you have used
all 5 opportunities, you can try again after 30 seconds.
When you can’t recall your unlock Pattern, PIN or Password:
< If you have forgotten your pattern >
If you logged in to your Google account on the phone but failed to enter the correct
pattern 5 times, tap the
Forgot pattern? button at the bottom of the screen. You are
then required to log in with your Google Account or you have to enter the Backup PIN
which you entered when creating your Pattern Lock.
If you have not created a Google account on the phone or you forgot Backup PIN, you
have to perform a hard reset.
If you forget your PIN or Password, you will need to perform a hard reset.
Caution: If you perform a hard reset, all user applications and user data will be
NOTE: If you have not logged into your Google Account and have forgotten
your Unlock Pattern, you will need to enter your Backup PIN.
5. Using the Hard Reset (Factory Reset)
If your phone does not restore to its original condition, use a Hard Reset (Factory Reset)
to initialize it.
Turn the power off.
Press and hold the
Power/Lock key + Volume Down key on the back of the
Power/Lock Key only when the LG logo is displayed, then immediately
press and hold the
Power/Lock Key again.
Power/Lock Key to continue or either of the Volume Keys to cancel.
If you perform a Hard Reset, all user applications, user data and DRM licenses
will be deleted. Please remember to backup any important data before
performing a Hard Reset.
6. Opening and switching applications
Multi-tasking is easy with Android, you can keep more than one application running
at the same time. There is no need to quit an application before opening another one.
Use and switch between several open applications. Android manages each application,
stopping and starting them as needed to ensure that idle applications don't consume
. A list of recently used applications will be
Tap the application you want to access. This does not stop the previous app
an app after using it.
To stop applications, tap
To remove an app from the recent apps list, swipe the app preview to the left or right.
7. Transferring music, photos and videos using Media
Apps tab > Settings > General tab > Storage to check out
the storage media.
Media sync (MTP) option.
Open the memory folder on your PC. You can view the mass storage content on
USB connected and
Charge phone from USB connection type list.
Hold your cell phone vertically, as you would a regular phone. Your phone has an
internal antenna. Be careful not to scratch or damage the back of the phone, as this
may affect performance.
When making/receiving calls or sending/receiving data, avoid holding the lower part of
the phone where the antenna is located. Doing so may affect call quality.
9. When the screen freezes
If the screen freezes or the phone does not respond when you try to operate it:
Power/Lock key for 10 seconds to turn your phone off. If it still
does not work, please contact the service center.
10. Do not connect your phone when you power on/off
might result in PC errors.
NOTE: If you use your phone with a broken display glass, your phone can
break even more or you can be injured. Make sure to visit the LG authorized
service center to get your phone repaired.
Return to the previous screen. Exit an app after using it.
Return to the Home screen from any screen.
Check what options are available.
NOTE: Proximity sensor
When receiving and making calls, the proximity sensor automatically turns the backlight off
and locks the touch screen by sensing when the phone is near your ear. This extends battery
life and prevents you from unintentionally activating the touch screen during calls.
Placing a heavy object on the phone or sitting on it can damage the LCD and touch screen
sensor to malfunction.
Getting to know your phone
This part encloses the battery compartment. Please do not open the back
Be careful not to damage the NFC touch point on the phone, which is part
On the home screen:
During a call: Control your
When playing a track:
Eject Button Aperture
SIM Card Tray
Switch your phone on/
holding this key
Short press to lock/
NFC Touch Point
Installing the micro-USIM card
Before you start exploring your new phone, you may choose to insert the micro-USIM
Insert the micro-USIM ejection tool that comes with the phone (or a thin pin) into
the angled corner to the right. There is only one possible way to fit the card snugly
into the tray.
NOTE: Make sure the gold contact area on the card is facing downwards.
Eject button aperture
Getting to know your phone
Charging your phone
Charge the battery before using it for the first time. Use the charger to charge the
battery. A computer can be also used to charge the device by connecting them via the
chargers, batteries or cables, it may cause battery charging delay or pop
up the message regarding slow charging, Or this can cause the battery to
explode or damage the device, which are not covered by the warranty.
The charger connector is at the bottom of the phone. Insert the charger and plug it into
an electrical outlet.
The battery must be fully charged initially to improve battery lifetime.
Do not open the back cover while your phone is charging.
Locking and unlocking the screen
If you do not use the phone for a while, the screen will be automatically turned off and
locked. This helps to prevent accidental taps and saves battery power.
When you are not using the phone, press the
to lock your phone.
If there are any programs running when you lock your screen, they may be still running
in Lock mode. It is recommended that you exit all programs before entering Lock mode
to avoid unnecessary charges (e.g. phone calls, web access and data communications).
To wake up your phone, press the
. The Lock screen will appear.
Touch and slide the Lock screen in any direction to unlock your Home screen. The last
screen you viewed will open.
To activate KnockON feature
Apps tab > Settings > General tab > Gestures.
Place a checkmark on
Double-tap the center screen quickly to unlock the screen. To lock the screen, double-
tap the status bar in any screen (except on the camera viewfinder) or empty area on the
NOTE: When turning the screen on, make sure you do not cover the proximity
sensor. Doing so will turn the screen off immediately after turning it on in order