ОңТҮстік қазақстан медицина академиясы, хабаршы №4 942, 2021 жыл, том 2



Pdf көрінісі
бет178/212
Дата14.10.2023
өлшемі3,39 Mb.
#114552
1   ...   174   175   176   177   178   179   180   181   ...   212
Байланысты:
№4942021том2

E20-E100
) conventional engines have to be refitted 
with more efforts. This is due to the characteristics of ethanol to dissolve certain rubber and plastic materials. 
Further, engines running with high blends of ethanol have to be refitted as pure ethanol has a much higher octane 
rating (116 AKI, 129 RON) than ordinary petrol. Therefore changes to the compression ratio and spark timing are 
needed to obtain maximum benefits. To refit an engine which will be fueled with pure ethanol, larger carburetor 
jets, which are about 30-40% larger by area, have to be installed. Additionally, below temperatures of 13 °C, 
ethanol engines also need a cold-starting system to maximize combustion and minimize uncombusted non-
vaporized ethanol. Depending on the particular customization requirements, refitting costs may run from a 
few euros for substitution of fuel lines to more than €500 if the fuel-supply system is fully upgraded (fuel lines, 
tank, pump, filter, etc) [3-4]. 
As an example, in Brazil some vehicles are exclusively running with pure ethanol. They are equipped with 
ethanol compatible materials and with on-board electronic engine management systems, which can adjust engine 
operation to ethanol fuelled conditions. 
Recently an increasing number of vehicles are manufactured with engines which can run on any 
petrol/bioethanol ratio from 0% ethanol up to 85% ethanol. Sensors of these 
flexible fuel vehicles 
(
E85 FFV
) can 
automatically detect the type of the fuel and adapt engine running. They adjust the air/fuel ratio and the ignition 
timing to compensate the different octane levels of the fuel in the engine cylinders. The main reason to limit 
ethanol content to 85 % is to enhance volatility conditions for cold start, particularly in cold climates. Therefore the 
technology does not need any cold start ancillary system. 
Worldwide, in February 2006, there were an estimated six million E85 FFVs on the road (WWI 2006). In 
Europe FFVs are used especially in Sweden, but also in other countries, 
e.g. in Germany or the United Kingdom, these vehicles are introduced. Pioneers in the European market are 
the manufacturers Ford and Saab. 
As opposed to Europe, in Brazil so called 
E100 FFV
s were introduced in 2003. This variant of the E85 
FFV technology is capable to operate either within the E20/E25 range, exclusively with hydrous ethanol (E100), or 
with any blend between E20/E25 and E100. The ethanol sensors used in the E85 versions are replaced in this 
technology by an advanced software component in the engine’s electronic control unit. This uses inputs from 
conventional oxygen sensors in the exhaust system (lambda sensors) and self-calibrates the engine to fuel 
requirements. This technology has proved feasible in Brazil in large part because the warm climate allows blending 
of hydrous ethanol to E20/E25 without the risk of phase separation. E100 FFVs have becom
e a sales phenomenon 
since their introduction in the Brazilian marketplace, in part because E100 is significantly less expensive than 
E20/E25 in much of the country (WWI 2006). 




Достарыңызбен бөлісу:
1   ...   174   175   176   177   178   179   180   181   ...   212




©emirsaba.org 2024
әкімшілігінің қараңыз

    Басты бет